BackSlope and Motion Accidental Calibration Reset
25 Feb 2010
On October 4, 2007, a "Slope and Motion Accidental Calibration Reset" problem was discovered in the FRS Twin and Single High Capacity GrainGage Software (version 1.3.9 and prior), and was reported as defect issue ID # 952. This critical issue causes a reset to the slope & motion sensor calibration, unbeknownst to the user. Weight data from research plots could then be recorded erroneously without the user recognizing the problem.
Click on the link below to open a PDF document explaining the corrective action to the above mentioned issue.
Slope and Motion Corrective Action (PDF)
